D14-6 VHMS - Forms 01/06 D14003
VHMS INITIALIZATION CHECK LIST
(Page 1 of 2)
FOR: 730E, 830E, 930E & 960E DUMP TRUCKS
Date of set-up (MM/DD/YY) / /
Distributor and
Branch
Person performing
initialization
Item
No.
To be checked when Check Item Results
Yes No
1. Key switch OFF Machine Model Number
Machine Serial Number
Service Meter Reading
Engine Serial Number
Alternator Serial Number
VHMS Serial Number
OrbComm Serial Number
2. Connect PC to VHMS controller Are they properly connected?
3. Key switch ON Check operation of controller LED
(after segment rotation, display to count-up).
4. Start VHMS Setting Tool program Select “VHMS Setting”, then “Set up & All clear“.
5. Initial setup of VHMS controller
Machine Information Setting(1)
Is Product Group correct? (Dump truck)
Is Machine Model correct? (ex. 930E)
Is Type correct? (ex. -2)
Is Variation Code correct? (ex. SE)
Is Serial Number correct?
6. Machine Information Setting (2) Is Engine Model - Type correct?
Is Engine Serial Number correct?
7. Date & Time Setting Is Time Zone correct?
Is Date correct?
Is Time correct?
Is DST (daylight saving time) correct?
8. GCC Setting Is correct GCC code selected for location?
9. Setting Data Verify Setting Data is Correct.
10. Setting of Payload Meter Set PLM time ± 2 minutes of VHMS time.
Start Time (set to 0)
Interval (set to 1)
To Next Page
Loading...
Need help?
General
