N2-14 Truck Cab N02019
Replace Door Handle or Latch Assembly
The cab doors are equipped with serviceable latch
handle assemblies (inner and outer). If they become
inoperative, they should be replaced by a new
assembly. The outer latch handle assembly on each
door is furnished with a key-operated lock to enable
the operator to lock the truck cab while the truck is
parked unattended.
1. Follow steps 1-6 procedure for door glass
replacement.
2. Refer to Figure 2-14. Remove cap screw and
nut (1) from inside door handle.
3. Remove 4 mounting screws (2) for the latch.
Remove old latch assembly.
* If replacing the latch assembly go to step 5.
4. If replacing the outside door handle, remove 3
screws holding handle to door panel (3, Figure
2-14).
Note: Only 1 screw is shown, the other 2 are behind
the latch assembly.
5. Install new latch assembly and align mounting
holes. Install 4 mounting screws. Be sure they
are tight.
6. Align inside door handle and install cap screw
and nut (3 Figure 2-14).
7. Follow steps 20-23 of the door glass replace-
ment procedure to complete the repair.
Door and Door Hinge Seal Replacement
1. The door assembly seal has only three mem-
bers to it (sides and top) and is glued on the
door. This seal can be replaced by peeling the
seal away from the door frame. Then use a suit-
able cleaner to remove the remaining seal and
glue material.
2. The area where the door seal mounts should be
free of dirt and oil. Spread or spray a glue which
is quick drying and waterproof onto the area
where the seal is to installed.
3. Install the seal so that the corners of the seal fit
up into the corners of the door frame (3, Figure
2-16).
4. The Door Hinge Seal is glued to the hinge. Use
the same procedure as above for this seal (2,
Figure 2-17).
To Next Page
Loading...
Need help?
General
