.
OPERATION
EXPLANATION OF COMPONENTS
LISTENING TO RADIO
1.
Turn the starting switch ON, then turn power switch (1) ON.
2.
Use band selector button (2) to select MW (AM), FM1 or FM2.
3. Select the station with the preset buttons (3).
REMARK
In case you do not promptly remember the number assigned to a
certain preset station, press auto-store/preset scan button (4) for
less than 0.5 second. The preset 6 stations will broadcast one after
another for 5 seconds each. When the desired station broadcasts,
press the button again and scan tuning stops.
4. If you want to tune in to a station that is not preset, use either
seek tuning button (5) or manual tuning button (6).
5.
Adjust the volume, balance, and tone as desired.
6. When turning the radio OFF, turn power switch (1) to the left
until it clicks.
REMARK
To switch to the radio when listening to a cassette, press the cassette eject button to stop the tape.
If you insert a cassette when listening to the radio, the tape will start to play.
LISTENING TO CASSETTE TAPE
1.
Turn the starting switch ON, then turn power switch (1) ON.
2.
Set the cassette with the exposed portion of the tape on the
right side and push it past the cassette door. The tape will
automatically start playing.
If the arrow indicating the direction of play is pointing to the
right, the top side is being played; if the arrow is pointing to the
left, the bottom side is being played.
When the tape reaches the end, it is automatically reversed
and the other side starts to play.
3.
When finished with the tape, press the cassette eject button to
eject the tape and automatically switch to the radio.
3 - 66
To Next Page
Need help?
General
