.
MAINTENANCE
SERVICE PROCEDURE
REPLACE POWER TRAIN OIL FILTER ELEMENT
WARNING
Immediately after the engine is stopped, the oil and parts are at high temperature, and may cause burns. To prevent this, wait
for the temperature to go down before starting the operation.
Before opening the filter cases, depress the brake pedal several times to release the pressure, then lock the brake pedal. If
there is still pressure inside the filter, oil may spurt out.
1. Open the engine side cover on the left of the machine.
2.
Remove bolts (1) and cover (2) is lifted up, then take out
element (3).
3. Clean inside of the case and the removed parts, then install a
new element.
Replace the O-ring with a new one.
CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL
WARNING
There is danger that oil may spurt out under internal pressure, so stand to the side, and gradually turn the plug to release internal
pressure before removing the plug.
1.
Place the machine on a horizontal place.
2.
Remove oil level plug (G) and check whether the final drive
case is filled with oil to lower edge of the plug hole.
3.
If the oil level is low, add oil through oil level plug (G).
Before removing the oil level plug (G), remove all the mud and
dirt from around the plug, and be careful not to let any dirt or
mud get in when adding oil.
4 - 55
To Next Page
Loading...
Need help?
General
