.
OPERATION
EXPLANATION OF COMPONENTS
CONTROL LEVERS, PEDALS
(1)
(2)
(3)
Work equipment lock lever
Parking brake lever
Joystick (steering, directional and
gear shift lever)
(4)
(5)
(6)
(7)
Brake pedal
Deceleration pedal
Blade control lever
Ripper control lever
WORK EQUIPMENT LOCK LEVER
WARNING
When leaving the operator's compartment, set the work equipment lock lever securely to the LOCK position. If the work
equipment lock lever is not at the LOCK position and the control levers are touched by mistake, it may lead to serious personal
injury.
If the work equipment lock lever is not set securely to the LOCK position, the work equipment may move and cause serious
injury. Check that it is in the position shown in the diagram.
When parking the machine or when carrying out maintenance, always lower the work equipment to the ground, then set the
work equipment lock lever to the LOCK position.
This lever (1) is a lock device for the blade control lever and ripper
control lever.
When it is set to the LOCK position, operation of the work
equipment is locked.
REMARK
When starting the engine, to ensure safety, always set the work
equipment lock lever to the LOCK position.
3 - 38
To Next Page
Loading...
Need help?
General
