.
OPERATION
OPERATION
CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL
WARNING
When removing the oil filler cap, oil may spurt out, so stop the engine
and wait for the oil temperature to go down, then push the cap down to
release the internal pressure before removing the cap carefully.
If oil has been added to above the H mark, stop the engine and wait for
the hydraulic oil to cool down. Then remove drain plug (P), loosen drain
valve (1), and drain the excess oil.
NOTICE
Check the oil level when the oil is at low temperature. If the oil is at high
temperature, the oil level will be higher.
Do not add oil if the oil level is above the H line. This may damage the
oil circuit and cause the oil to spurt out.
1.
Lower blade to the ground and stop the engine. Wait for 5
minutes before checking oil level. Oil level should be between
the H and L in sight gauge (G).
REMARK
When inspecting, if the machine is at an angle, move it to a level
place to carry out the check.
2.
If the level is below the L mark, add oil through oil filler (F) as follows.
1) Push down cap of oil filler (F) to release the air and remove the internal pressure.
2)
Keep cap pushed down, turn it slowly counterclockwise, then remove cap.
3)
Refill the specified quantity of oil through oil filler (F).
4) Install cap.
When installing cap to the tank, push it down, then turn it clockwise.
REMARK
If the cap is not installed correctly, it will cause leakage of oil.
When installing the cap, press the cap down, and turn it until it is securely in contact with the stopper.
The cap is the lock addition type.
About handling method of cap with the lock, see "CAP WITH LOCK (PAGE 3-49)".
3 - 83
To Next Page
Loading...
Need help?
General
