BRAKING
5-20
BRAKING
While driving, you may reduce your speed with the service brake
(1). After the machine has stopped, you must secure it with the
parking brake (2).
PULLING THE PARKING BRAKE
1. Press the locking button.
2. Pull up the parking brake lever.
3. Release the locking button. The control lamp of the parking
brake lights up.
RELEASING THE PARKING BRAKE
1. Lift up the parking brake lever a little.
2. Press the locking button.
3. Push the parking brake lever down.
4. Release the locking button. The control lamp of the parking
brake goes out.
BRAKING WITH THE SERVICE BRAKE
If the braking delay is not sufficient by relieving the pressure
from the accelerator pedal, you must brake the machine with the
service brake. For this purpose, press down the brake pedal.
Theservicebrake(1)canalsobeusedtoadaptthedriving
speed to the respective driving and operating situation (2), inde-
pendent of the accelerator pedal position.
If it is required to press down the accelerator pedal completely, in
order to be able to use the full-load output of the engine of the
work hydraulic system, you can nevertheless use the brake ped-
al to reduce the speed of the machine or to stop it completely.
1
2
1
2
To Next Page
Loading...
Need help?
General
