7
Internet faxing
7-16 bizhub 362/282/222
7.4 Specifying additional functions
You can add the following functions by pressing the [Fax/Scan] key on the
control panel, then touching [Menu] on the screen that appears.
2
Note
If the optional fax kit has been installed, [Menu] changes to [Fax Menu].
2
Note
The following functions have no effect, even if settings have been
specified.
- "File name" on the Network tab
- "E-Mail Notification" on the Network tab
Item Description
Setting 1
**(Set 1)
TSI Select the entered information, such as this machine‘s name, fax
number or address, that is printed at the edge of the page. In addition,
the destination name registered with a one-touch dial button can be
printed in this information. For details on registering transmission
source information, refer to "Registering transmission source names"
on page 10-5.
TX Report Select under which conditions the transmission report is to be output.
Default: Outputs according to the specifications of the administrator.
ON: Prints regardless of the transmission results.
If TX Fails: Prints only when undeliverable.
OFF: Does not print regardless of the transmission results.
2in1 Select whether to send using the 2in1 function (printing two pages to
fit on one page).
2-Sided TX Select whether to perform double-sided transmission. You can spec-
ify the position of the binding margin and the document orientation.
Rotation TX Select whether to rotate the image according to the paper orientation
of the receiving machine.
The quality can be specified as 200 dpi or less when sending A4 size.
Setting 2
**(Set 2)
Priority TX Select whether a job is given priority over others.
Timer TX
Setting
Select whether to set the send time. Specifies the send time when
"ON" is selected.
Stamp Specify whether the document is stamped to indicate that it has been
scanned. The document must be loaded into the ADF.
2
Note
To use the Stamp function, optional stamp unit must be
installed.
To Next Page
Loading...
Need help?
General
