bizhub C3850/C3350 1-53
1.5 Available operations in Administrator mode
1
1.5.7 [Network] tab
[General Settings] - [Ethernet Settings]
To display: Administrator mode - [Network] - [General Settings] - [Ethernet Settings]
Specify the network speed, and check the MAC address.
[General Settings] - [Local Interface Settings]
To display: Administrator mode - [Network] - [General Settings] - [Local Interface Settings]
Change the time-out time to limit a communication with the computer.
[TCP/IP Settings] - [TCP/IP Settings]
To display: Administrator mode - [Network] - [TCP/IP Settings] - [TCP/IP Settings]
Configure the TCP/IP settings.
[TCP/IP Settings] - [IPv4 Settings]
To display: Administrator mode - [Network] - [TCP/IP Settings] - [IPv4 Settings]
Assign an IP address (IPv4) to this machine.
Item Description
[Speed/Duplex] Select the network speed according to your environment.
[Auto] is specified by default.
[MAC Address] Displays the MAC address of the network interface card of this machine.
Item Description
[I/O Timeout] When this machine is connected via a USB device to the computer, change the
communication time-out time if necessary.
[60] sec. is specified by default.
Item Description
[TCP/IP] Select whether or not to use TCP/IP.
[Enable] is specified by default.
[LPD] Select whether or not to use LPD (Line Printer Daemon).
[Enable] is specified by default.
[SLP] Select whether or not to use SLP (Service Location Protocol).
[Enable] is specified by default.
[LLMNR] Select whether or not to use LLMNR (Link-local Multicast Name Resolution).
[Enable] is specified by default.
Item Description
[IP Address Setting
Method]
When automatically specifying the IP address, select the method for automatic
retrieval.
• [DHCP]: [ON] (selected) is specified by default.
• [BootP]: [OFF] (not selected) is specified by default.
• [ARP/PING]: [OFF] (not selected) is specified by default.
• [Auto IP]: [ON] (selected) is specified by default.
[IP Address] When manually specifying the IP address, enter the fixed IP address.
[Subnet Mask] When manually specifying the IP address, enter the subnet mask.
[Default Gateway] When manually specifying the IP address, enter the default gateway.
[Domain Name Auto-
matic Acquisition]
When using the DHCP or other protocols, select whether or not to automati-
cally retrieve the domain name.
[Enable] is specified by default.
[DNS Server Automatic
Acquisition]
Select whether or not to automatically obtain the address of the DNS server.
[Enable] is specified by default.
To Next Page
Loading...
Need help?
General
