Handling film
Where is the emulsion?
To achieve the best possible reproduction from the scanner, the film and film holder should be
free from dust and dirt. Always work with processed film in a clean, dust-free environment.
Handle film by the edges or mount to prevent fingerprints and dirt marring the image area.
Special lint free gloves are available from photographic equipment retailers for film handling as
well as anti-static cloths, brushes, and blowers for removing dust. Film cleaner can be used to
remove oil, grease, or dirt from film; carefully follow the manufacturer's instructions and precau-
tions for the film cleaning solvent.
When film is scanned, the emulsion side of the film should be down. When viewing the film
image, if the image is orientated correctly rather than a mirror image, the emulsion side is facing
down. If the image is abstract or symmetrical so its orientation is difficult to determine, the emul-
sion is down if the frame numbers and edge markings can be read correctly. The dull side of any
film is the emulsion side.
Film strips of up to six frames can be
loaded into the FH-U2 film holder. To
open the holder, lift the latch and
open the cover (1).
With the emulsion down, place the
film in the holder and under the
retaining tabs (2). Align the film
with the frame apertures.
Carefully lower the cover
until the latch clicks into
place. Take care not to
move the film during
this operation.
Loading 35mm film strips
Loading the film holders
18 Loading the film holders
1
2
2
To Next Page
Loading...
Need help?
General
