14 ELECTRICAL SYSTEM 212
– Close the fuse box cover.
Finishing work
– Fit the seat. ( p. 170)
14.6 Changing the low beam bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Preparatory work
– Switch off all power consumers and the engine.
100742-10
Main work
–
Fold up the combination instrument. Pull the lug
out of the rubber retainer
.
– Remove the rubber retainer.
To Next Page
Loading...
Need help?
General
