RIDING INSTRUCTIONS 31
9.1Checks before putting into operation
Info
Make sure that the motorcycle is in a perfect technical condition before use.
In the interests of riding safety, make a habit of making a general check before you ride.
– Check the gear oil level. ( p. 88)
– Check the fuel supply.
– Check the chain tension. ( p. 55)
– Check the chain for dirt. ( p. 54)
– Check the tire condition. ( p. 69)
– Check the tire air pressure. ( p. 70)
– Check the front brake fluid level. ( p. 59)
– Check the rear brake fluid level. ( p. 63)
– Check the front brake linings. ( p. 60)
– Check the rear brake linings. ( p. 64)
– Check that the brake system is functioning properly.
– Check the coolant level. ( p. 77)
– Check the settings of all controls and ensure that they can be operated smoothly.
– Check that the electrical equipment is functioning properly.
9.2Starting
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may result in unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an enclosed
space without an effective exhaust extraction system.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
– Always warm up the engine at low engine speeds.
Info
If the motorcycle is unwilling to start, the cause can be old fuel in the float chamber. The flammable elements of the fuel
evaporate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
Engine has been out of use for more than one week
–
Empty the carburetor float chamber. x ( p. 87)
– Turn handle of the fuel tap to the ON position.
Fuel can flow from the fuel tank to the carburetor.
– Remove the motorcycle from the stand.
– Shift gear to neutral.
(250/300 EXC AUS)
– Turn the emergency OFF switch to the position .
The engine is cold
(EXC EU, EXC SIX DAYS)
– Pull the choke lever to the stop.
(EXC AUS, XC‑W/XC)
– Pull out the choke lever all the way.
– Press the electric starter button or press the kickstarter robustly through its full range.
Info
Do not open the throttle.
To Next Page
Loading...
Need help?
General
