12 TUNING THE CHASSIS
194
Info
Turn clockwise to increase the spring preload; turn
counterclockwise to reduce the spring preload.
Adjusting the spring preload has no influence on
the absorption setting of the rebound.
Basically, however, you should set the rebound
damping higher with a higher spring preload.
Finishing work
– Take the motorcycle off the front lifting gear. ( p. 209)
– Install the front fender. ( p. 239)
– Remove the rear of the motorcycle from the lifting gear.
( p. 207)
12.5 Bleeding the fork legs (890 ADVENTURE R RALLY)
Preparatory work
– Raise motorcycle with rear lifting gear. ( p. 207)
– Remove the front fender. ( p. 238)
– Lift the motorcycle with the front lifting gear. ( p. 208)
To Next Page
Loading...
Need help?
General
