MAINTENANCE WORK ON FRAME AND ENGINE 114
Installing the rear wheel x
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
– Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
– After installing the rear wheel, always operate the foot brake until the pressure point is reached.
–
Check the rear hub rubber dampers. x (
p. 116)
100571-10
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing. x
– Clean and grease shaft seal ring and bearing surface of the spacer.
Long-life grease ( p. 215)
– Clean and grease the thread of the wheel spindle and nut.
Long-life grease ( p. 215)
– Mount the rubber dampers and rear sprocket carrier in the rear wheel.
– Place the rear wheel in the swingarm and bring the brake disc on the brake caliper into
contact.
To Next Page
Loading...
Need help?
General
