75PERIODIC SERVICE
7. Run the engine at idle speed, set the direction switch
to the neutral position.Then operate the control lever
and the steering wheel for about five minutes.
Stop the engine and make sure that the oil quantity is
sufficient through the oil level gauge.
Hydraulic oil port is under the floor. Take up the mat,
remove the bolts and detach the cover.
A If there are deposits in the tank, wipe them all with a
clean rag and diesel oil.
A Use great caution not to admit any foreign particles
into the tank.
BReplacing air cleaner element
Open the hood, and remove the cover and both filter
elements, change both filter elements and clean the
inside of the case. Reinstall the filter elements and the
cover being careful to install the cover so that its TOP
mark (arrow) faces upwards.
(1) Oil level gauge
(1) Mat
(1) Bolts
(2) Cover
(1) Oil port cap
Hydraulic oil
volumes
Hydraulic tank 39 L
Whole oil volumes 60 L
(1) Outer element
(2) Inner element
(3) Cramp
(4) Cover
To Next Page
Loading...
Need help?
General
