81PERIODIC SERVICE
BTire pressure
If the air pressure in the tire is too high or too low, the life
of the tire will be shortened. Make routine checks of the air
pressure in tires. Check the tires and rims for damage and
eliminate defects before starting operation.
C Tire pressure
1. Insufficient tire pressure.
Too small an amount of air in the tire can cause it to
have excessive slack, which makes for faster wearing
down of the tread.
2. Correct tire pressure.
3. Excessively high tire pressure.
Too high a tire pressure causes the tractive force of
the machine to decrease, or the tire to slip. There is
also the risk of a blow out.
BChanging tires
C Removal
1. Loosen the wheel nuts, each by one turn on the wheel
to be removed.
2. Lift the machine so that the wheel to be removed is just
raised off the ground. Place the machine on
jackstands. Then remove the wheel nuts and remove
the wheel from the axle.
C Fitting
1. Mount wheel on axle and lightly tighten the wheel nuts.
2. Lower the machine to the ground, and tighten the
wheel nuts to the specified torque in the order shown
above.
(1) Deficient
(2) Correct
(3) Excessive
(4) Ground level
Type R065
Tire size 12.5-18 MPT
Bucket Pallet forks
front rear front rear
12.5-18 MPT 2.5 bar 2.0 bar 3.0 bar 2.0 bar
Tightening torque 490 N-m
To Next Page
Loading...
Need help?
General
