3-23
Preparation before Use > Registering Destinations in the Address Book
5
Check if the destination entry is correct and select the [OK]
key.
The destination is added to the Address Book.
Registering a Group
Compile two or more contacts into a group. Designations in the group can be added at the same time. When adding a
group, a maximum of 20 groups can be added in the Address Book.
1
Display the screen.
[System Menu/Counter] key > [ā²] [ļ±] key > [Edit Destination] > [OK] key > [ā²] [ļ±] key >
[Address Book] > [OK] key > [Menu] > [ā²] [ļ±] key > [Add Address] > [OK] key >
[ā²] [ļ±] key > [Group] > [OK] key
2
Add the name.
1 [ā] [āŗ] key > [Group Name] > [Edit]
2 Enter the group name displayed on the Address Book and select the [OK] key.
3
Select the members (destinations).
1
[ā] [āŗ] key > [Group Member] > [Edit] > [Menu] > [ā²] [ļ±] key > [Add Member] > [OK] key
2 Select the member you want to add, and select the [OK] key.
3 Select the destination to be registered in the group from the destinations registered in the
contact addresses and select the [OK] key.
The selected member is added to group member.
Members can be added by repeating steps 3-1 to 3-3.
4 Select the [Back] key.
NOTE
To add a group, you need individually added destinations. Register one or more individual destinations as needed
before proceeding. Up to 100 individually registered destinations and a combined total of up to 5 SMB and FTP
destination folders can be registered in a single group.
NOTE
Up to 32 characters can be entered.
Refer to the following for details on entering characters.
Character Entry Method
(page 11-8)
NOTE
Select [Menu] and select [Search(Name)] to search using a name.
To Next Page
Loading...
Need help?
General
