6-18
Using Various Functions > Functions
File Name Entry
Adds a file name.
Additional information such as job number and date and time can also be set. You can check a job history or job status
using the file name, date and time, or job number specified here.
Enter the file name (
up to 32 characters), and select [OK].
To add date and time, select [Date] and the [OK] key. To add job number, select [Job No.] and the [OK] key. To add
both, select [Job No. + Date] or [Date + Job No.] and the [OK] key.
Job Finish Notice
Sends E-mail notice when a job is complete.
Users can be notified of the completion of a job while working at a remote desk, saving the time spent waiting beside the
machine to finish.
Priority Override
Suspends the current job and gives a new job top priority.
The suspended job resumes after the other job is finished.
(Value: [Off] / [On])
NOTE
PC should be configured in advance so that E-mail can be used.
Command Center RX
(page 2-48)
E-mail can be sent to a single destination.
Item Description
Off Disables the function.
On Address Book Select the notification destination from the Address Book or External Address Book
*1
.
Select the destination on the Address Book or Ext Address Book screen, then select the [OK] key.
*1 For details on the External Address Book, refer to the following:
Command Center RX User Guide
Address Entry Enter E-mail address directly. Enter the address (up to 128 characters) and select the [OK] key.
NOTE
• This function is not available if current job was an override.
• Priority override may not be available depending on the status of the current print job and memory usage.
To Next Page
Loading...
Need help?
General
