5-4
Operation on the Machine > Loading Originals
2
Place the originals.
1 Put the side to be scanned face-up. Slide the leading edge into the document processor as
far as it will go.
2 Open the original stopper to fit the size of the original set (Original size: Legal).
NOTE
For details on Original Orientation, refer to the following:
Original Orientation
(page 6-15)
IMPORTANT
Confirm that the original width guides exactly fit the originals. If there is a gap,
readjust the original width guides. The gap may cause the originals to jam.
Ensure that loaded originals do not exceed the level indicator. Exceeding the
maximum level may cause the originals to jam.
Originals with punched holes or perforated lines should be placed in such a way
that the holes or perforations will be scanned last (not first).
To Next Page
Loading...
Need help?
General
