Quick Start
3
In the New password text box, type a password for a local user. A password is
a maximum of 32 characters. A blank password is allowed.
4
In Confirm password, type the password again.
5
Click OK to save the password.
Device Discovery
Discovery is a process that checks networks for printing devices. If new
devices are found, then the application updates its database with information
about the device. This process can be performed manually for single or multiple
devices, or it can be scheduled to run automatically according to a set schedule.
It is also possible to exclude devices from being discovered.
When the application is launched for the first time, or when a new workspace is
opened, the Add Device Wizard automatically launches.
Adding Devices
You can use the Add Device Wizard to add devices to the view list.
1
Click Device > Discovery > Add Devices.
2
In the Add Device Wizard, select a method for adding devices:
Express
Uses predefined communication settings to find devices in the local network.
Custom
Lets you select settings to find devices on any network.
3
For the selected method, complete the wizard and click Finish to begin
discovery.
Custom Options for Adding Devices
Custom options are available when Custom is selected in the Add Device
Wizard. You can select the discovery process to run on your local network, a
specific IP address, or a range of IP addresses. Continue through the wizard to
select the following options:
On your local network
Select discovery type, TCP/IP port, SNMP options, SSL options, and
discovery start time.
By IP address
Type specific IPv4 or IPv6 addresses or host names and click Add to add
them to the Selected targets list. You can also click Import to search for a
valid IP address list (.CSV or .TXT). An entry can be removed from the
Selected targets list by selecting it and clicking Remove. Click Next to
continue through the wizard and select TCP/IP port, SNMP options, SSL
options, and discovery start time.
By IP address range
Type valid starting and ending IPv4 addresses and click Add to add them to
the Selected network segments list. An entry can be removed from the
User Guide
1-2
To Next Page
Loading...
Need help?
General
