COMPONENT MAINTENANCE MANUAL
AVIATION PRODUCTS
Model FA5000
Rev. 02 Page 6
July 21/17
Introduction
23−70–30
Use or disclosure of information on this sheet is subject to
the restrictions on the cover page of this document.
I. SPECIAL TOOLS AND TEST FIXTURES
This section provides a listing of all required tools, fixtures, and equipment which are
not common maintenance tools. It also provides a description of the Read−Out Cen-
ter (ROC)/CVDR Automated Test Station (CATS) as used with the Recorder Inter-
face Unit (RIU) to test and download from the FA5000.
J. ILLUSTRATED PARTS LIST
This section contains parts location diagrams and parts listings for all versions of the
Model FA5000CVR listed on the Title Page of this manual.
6. DOCUMENT VERIFICATION
All CMM drawings, illustrations, wiring diagrams, and block diagrams were validated
against existing engineering source material. All Testing & Fault Isolation, Disassembly
and Assembly procedures have been verified against the actual performance of the unit
under test conditions as indicated in Table 1 below.
Table 1 identifies the sections of the CMM that underwent a Shop Verification process
and the date of the verification. In addition, a Component Maintenance Manual Verifica-
tion Report that identifies the technician who performed the procedure and Engineer/
Technical Writer who verified the procedure along with a Quality Assurance Engineer ap-
proval signature is kept on file with the CMM sign−off release form. For a copy of the
Component Maintenance Manual Verification Report for this version of the CMM, please
address inquiries to the following:
L3 Technologies
Aviation Products
Sarasota, Florida 34230
Phone: (941) 371–0811
FAX: (941) 377–5591
Table 1. Shop Verification
Procedure Chapter Date of Verification
Testing & Fault Isolation 100 Sep.−11/13
Disassembly 300 Sep.−10/13
Assembly 700 Sep.−10/13
NOTE: Contact L3 Technologies, Aviation Products, to verify this date-sensitive
information when using this manual to develop other documentation. The
L3AP Publication index is located at www.L−3.com or L−3ar.net.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General
