7: Services
SLC™ 8000 Advanced Console Manager User Guide 124
V3 User Read-Write
V3 User Trap
3. To save, click the Apply button.
Services Commands
Go to Services Commands to view CLI commands which correspond to the web page entries
described above.
NFS and SMB/CIFS
Use the Services > NFS & SMB/CIFS page if you want to save configuration and logging data onto
a remote NFS server, or export configurations by means of an exported CIFS share.
Mounting an NFS shared directory on a remote network server onto a local SLC directory enables
the SLC advanced console manager to store device port logging data on that network server. This
configuration avoids possible limitations in the amount of disk space on the SLC unit available for
the logging file(s). You may also save SLC configurations on the network server.
Similarly, use SMB/CIFS (Server Message Block/Common Internet File System), Microsoft's file-
sharing protocol, to export a directory on the SLC 8000 advanced console manager as an SMB/
CIFS share. The SLC unit exports a single read-write CIFS share called "public," with the
subdirectory the config directory, which contains saved configurations and is read-write.
The share allows users to access the contents of the directory or map the directory onto a
Windows computer.
Passphrase/
Retype
Passphrase
Passphrase associated with the password for a user with read-only authority. Up to 20
characters. If this is not specified it will default to the v3 Read-Only Password.
User Name
SNMP v3 is secure and requires user-based authorization to access
SLC MIB objects.
Enter a user ID for users with read-write authority. The default is snmprwuser. Up to
20 characters.
Password/
Retype Password
Password for the user with read-write authority to use to access SNMP v3. The default
is SNMPRWPASS. Up to 20 characters.
Passphrase/
Retype
Passphrase
Passphrase associated with the password for a user with read-write authority. Up to 20
characters. If this is not specified it will default to the v3 Read-Write Password.
User Name SNMP v3 is secure and requires user-based authorization to access SLC unit MIB
objects. Enter a user ID for users with authority to send traps. The default is
snmptrapuser. Up to 20 characters.
Password/
Retype Password
Password for the user with authority to send v3 traps. The default is
SNMPTRAPPASS. Up to 20 characters.
Passphrase/
Retype
Passphrase
Passphrase associated with the password for a user with authority to send v3 traps. Up
to 20 characters. If this is not specified it will default to the v3 Trap Password.
To Next Page
Loading...
Need help?
General
