7: Services
SLC™ 8000 Advanced Console Manager User Guide 144
Device Attributes
Registration Host
Messaging Host
Interval between status
updates
Number of minutes between status updates sent from the client to the server.
Valid values are 1 - 60 minutes. The default is 2 minutes.
Interval between FW
and Config Checks
Number of hours between checks for firmware and configuration updates
initiated by the server. Valid values are 1 - 72 hours. The default is 24 hours.
Firmware Updates via
ConsoleFlow
If enabled, firmware updates can be initiated by ConsoleFlow for the SLC. The
device will check for updates per the frequency defined by Interval between FW
and Config Checks, and if a firmware update is found, the update will be
downloaded to the device and applied to the alternate boot bank. Enabled by
default.
Configuration Updates
via ConsoleFlow
If enabled, configuration updates can be initiated by ConsoleFlow for the SLC.
The device will check for updates per the frequency defined by Interval between
FW and Config Checks, and if a configuration update is found, the update will
be downloaded to the device and applied to the current boot bank, and the SLC
will be immediately rebooted. Enabled by default.
Reboot after Firmware
Update
If enabled, the SLC will automatically reboot after a successful firmware update
via ConsoleFlow. Disabled by default.
Connect to Cloud If enabled, the SLC ConsoleFlow client uses Cloud server settings for
registration. Otherwise it uses On-Premise server settings. Enabled by default.
i.e., By default, ConsoleFlow Active connection is to Cloud.
Device Name The device name displayed in the ConsoleFlow server UI. Valid characters are
alphanumeric characters, dash "-", and underscore "_". The default is the
device type (SLC) with the last 4 characters of the Eth1 MAC address
appended.
Device Description Long description that is displayed in the ConsoleFlow server UI.
Device ID The unique device identifier. The ID is 32 alphanumeric characters. The ID may
be provisioned using Lantronix Provisioning Manager (LPM). Contact Lantronix
Tech Support for more information on LPM.
S/N View-only field. Displays the serial number.
Registration Host Hostname of the server the client registers with. The Host Name should start
with api.
Registration Port The TCP port on the Registration Host. Defaults to 443.
Use HTTPS for
registration
If enabled, HTTPS (instead of HTTP) is used for registration. Enabled by
default.
Validate certificates with
HTTPS
If enabled, use a certificate authority to validate the HTTPS certificate. A
certificate authority file can be uploaded on the Web Server page. Disabled by
default.
Messaging Services If enabled, messaging services are used for status updates and commands.
Enabled by default.
Messaging Host Hostname of the server used for messaging services. The hostname should
start with mqtt.
Messaging Port The TCP port on the Messaging Host. Defaults to 443.
To Next Page
Loading...
Need help?
General
