Lantronix XPort User Guide

7: 59BSetup Mode: Channel Configuration
XPort® Device Server User Guide 54
Command String
Result if remote IP is 129.1.2.3 and remote port is 1234
Once it connects, the unit stops trying to connect to any others.
If this connection fails, the unit continues to scroll through the
table until it is able to connect to another IP in the hostlist.
Hostlist supports a minimum of 1 and a maximum of 12 entries.
Each entry contains the IP address and the port number.
The hostlist is disabled for Manual and Modem Modes. The unit
does not accept a data connection from a remote device when
the hostlist option is enabled.
Figure 7-2. Apply Settings and Apply Defaults
To enable the hostlist:
1. Enter a Connect Mode of 0x20 (2X), where X is any digit. The menu shows you
a list of current entries already defined in the product.
2. To delete, modify, or add an entry, select Yes. If you enter an IP address of 0.0.0.0, that
entry and all others after it are deleted.
3. After completing the hostlist, repeat the previous step if necessary to edit the hostlist
again.
4. For Retrycounter, enter the number of times the Lantronix unit should try to make a
good network connection to a hostlist entry that it has successfully ARPed. The range is
1-15, with the default set to 3.

Lantronix XPort Specifications

General

Brand	Lantronix
Model	XPort
Category	Server
Language	English