6. Software Control – Lightware Device Controller Software MX-FR Series Modular Matrix Frames – User's Manual 98
User Preferences
working mode. These settings are saved by the LDC and applied next
time when the software is started (independently from the type of the
matrix):
▪
▪
switch)
▪
▪ Switch All
INFO: The size of the LDC window is also restored from the last run.
Terminal Window
This general purpose terminal is intended mainly for testing and
IP LAN or USB connection. All commands can be used here that are
typed directly.
By default, commands are automatically surrounded by framing
brackets. Every sent command and every received response gets an
distinguish between them.
The timecode in every row shows the exact time when the command
was sent or the response received.
If the Command framing checkbox is unchecked, you can send multiple
commands together, however in this case you have to type in the
framing brackets manually.
The terminal can be also opened after starting the LDC - press the
Terminal button on the Device discovery page on the bottom of the
window.
TIPS AND TRICKS: The typed commands can be 'browsed' when
the cursor is in the command line and you press the up button on
the keyboard. The commands are stored until the LDC is closed.
#terminal
User Preferences Tab
Terminal Window
To Next Page
Loading...
Need help?
General
