D9U004GKC-0101
30
9 Entry into Operation
WARNING!
Risk of injury when working with the chair!
► Ensure that the chair is disconnected from the mains connection before commissioning and maintenance.
WARNING!
Risk of damage to property due to incorrect commissioning!
► Ensure that commissioning is performed exclusively by customer service or trained hospital personnel.
NOTE: For safe and easy handling, LINET® recommends the chair be assembled by two technicians at a time.
Set the chair as follows:
► Unpack the chair.
► Check the delivery (see Scope of Delivery and Chair Variants).
► Install equipment and accessories (see Installation).
► Set up the chair exclusively on a suitable oor surface (see Transport).
► Ensure that the mains cable does not collide or get stretched when adjusting the chair.
► Check that the plug is inserted correctly.
► Do not leave any extension cords or power strips loose on the oor.
► Ensure that all of the required mechanical and electrical prevention mechanisms are available on site.
► There is no mains switch on the chair, i.e. the mains cable is the only means to isolate the chair from the mains.
Ensure that the mains cable is always accessible.
► Have the separable plug of the mains cable changed and maintained exclusively by qualied and trained service technicians
authorised by the manufacturer.
WARNING!
Material damage due to temperature difference
► If there is a considerable temperature difference between the chair and the place of operation (after transport/stage),
leave the chair unconnected for 24 hours for the difference to balance itself.
To Next Page
Loading...
Need help?
General
