D9U004GKC-0101
54
12.4 Goepel footrests (hereinafter only Goepel)- electrically operated
Manipulation:
► Insert the Goepel into the holder and secure it from below with a rosette
► Movement of the arm from the centre / to the centre of the chair:
■ Grab the Goepel arm
■ Slightly loosen the bottom rosette
■ Set the Goepel to the desired position
■ Retighten the rosette
■ Make sure that the footrest arm is held rmly
► Movement of the arm up / down:
■ The movement is performed using the buttons on the hand controller intended
for the movement of the Goepel
► Goepel bowl movement:
■ grasp the bottom of the Goepel bowl
■ Slightly loosen the upper rosette
■ Set the Goepel bowel to the desired position
■ Retighten the rosette
■ Make sure the Goepel bowel is held firmly
Change for footrest
(if both variants are ordered as part of the chair)
(footrests / footrests Goepel)
■ grab the Goepel
■ unscrew the lower rose
■ remove Goepel from the holder
■ set the Goepel aside
■ grab the footrest
■ insert footrest into the holder
■ make sure that the footrests is held firmly
WARNING!
► Improper handling can cause injury to the patient, or operator!
► Goepel is not intended for stepping and leaning the body - there is a risk of instability of the chair
► Goepel is intended to support the calf when the patient is sitting / lying down
► Always make sure that the Goepel is sufficiently secured before use
► In the event of an overload, the Goepel will drop - immediately relieve the support - there is a risk of damage
chair
► When handling the Goepel take extra care - risk of collisions with surrounding objects (eg. chair)
► When handling the chair (moving down) take extra care to avoid collisions with surrounding objects (eg. chair)
To Next Page
Loading...
Need help?
General
