Linksys LAPN300 User Manual

Firmware Upgrade
The firmware (software) in the wireless access point can be upgraded by using HTTP/HTTPS, or TFTP.
Check the Linksys support website (http://www.linksys.com/support
) and download the latest
firmware release to your storage such as PC. Then, perform firmware upgrade by
following the steps below.
During firmware upgrade, do not power off device or disconnect the Ethernet cable. The access point
will reboot automatically after firmware upgrade is completed.
Figure 46: Firmware Upgrade Screen
To perform the firmware upgrade from local PC:
1. Click the
Browse button and navigate to the location of the upgrade file.
2. Select the upgrade file. Its name will appear in the
Upgrade File field.
3. Click the
Upgrade button to commence the firmware upgrade.
To perform the firmware upgrade from TFTP server:
1. Enter the IPv4 address of the TFTP server and the source file. The source file is the firmware
filename you stored in your TFTP server.
2. Click the
Upgrade button to commence the firmware upgrade.
73

Linksys LAPN300 Specifications

General

Color	multi, white
Wi-Fi Speed	300 gigabits per second
Frequency Band	2.4 ghz
QoS Traffic Prioritization	no
Wireless Standard	n
Data Encryption	yes
Encryption Type	other, wep, wpa, wpa2
Security Features	rogue ap detection; ssid to vlan mapping; 802.1x supplicant
Ports	rj-45
Bluetooth	no

Weight and Dimensions

Height	1.72 inches
Width	9.33 inches
Net Weight	1.08 pounds