Manitowoc 14000 Service Maintenance Manual

Reference Only
Manitowoc Published 09-05-14, Control # 226-02 2-27
14000 SERVICE MANUAL HYDRAULIC SYSTEM
2
Charge Pressure Adjustment
The following adjustment is only required when a system
fails the Charge Pressure Test described in this section.
1. Scroll to diagnostic screen for corresponding function
(see Figure 2-15
).
2. Start and run engine at high idle. With function in neutral,
system pressure on diagnostic screen should read 320
to 370 psi (22 to 25.5 bar).
3. If specified pressure is not indicated, stop engine and
connect an accurate 0 to 1,000 psi (0 to 69 bar)
hydraulic pressure gauge to coupler at corresponding
pressure sender.
4. Repeat step 2
, if specified pressure is still not indicated:
• Do a Pressure Sender Test as instructed in this
section. Replace faulty pressure sender if needed.
• Do a Control Calibration as instructed in this
section.
If specified pressure is still not indicated:
• If pressure is too high, check that pump neutral is
adjusted properly. If pressure is still high, adjust
charge pressure relief valve.
• If pressure is too high, adjust charge pressure relief
valve. If you cannot raise charge pressure,
excessive system leakage is indicated.
5. To adjust charge pressure:
See Figure 2-26
for following procedure.
a. Loosen lock nut (1).
b. Adjust adjusting plug (2).
- Turn in to increase pressure.
- Turn out to decrease pressure.
c. Once specified pressure is indicated, hold adjusting
plug (2) in position and securely tighten lock nut (1).
6. Stop engine and remove gauge from transducer gauge
port.
Item Description Hex Wrench Size
1 Lock Nut 1/2 in (
2
Adjusting Plug
Series 030-100
1-1/16 in
Adjusting Plug
Series 030-100
1-5/8 in
1
P1600a
FIGURE 2-26
2
Typical Pump Installation

Manitowoc 14000 Specifications

General

Brand	Manitowoc
Model	14000
Category	Construction Equipment
Language	English