ELECTRIC SYSTEM 14000 SERVICE MANUAL
3-4
Published 09-05-14, Control # 226-02
Node Table Heading Descriptions
The CAN tables on the following pages provide information
found on the crane’s electrical schematics at the end of this
section.
Connector codes—for example, 34-R—are interpreted as
follows:
The number 34 is the cable number.
The number 3 is the node number.
The number 4 is the receptacle number where the item
is located on the node.
The last number R is the pin number of the receptacle.
Function Type—indicates the type of connection, such as
power, ground, signal, analog input (AI), digital input (DI),
digital output (DO), etc.
Receptacle/Pin No.—(Engine Node-0 only) indicates input
to receptacle number and pin number code.
Wire No.—(Engine Node-0 only) indicates wire to computer
receptacle or wire number code.
CAN Packet Number—indicates location of items for all
nodes except node 0 which does not have CAN packet
numbers.
For example, in Master Node 1, CAN92-6-32 (Swing Park
Switch):
CAN92 is the packet location number.
Number 6 is the bank where information is stored.
Number 32 is the identifier for that item.
To Next Page
Loading...
Need help?
General
