Miele TDA 140 C User Manual

Problem solving guide
30
With the help of the following notes minor faults in the performance of the
appliance, some
of which may result from incorrect operation, can be put right
without contacting the Service Department.
 Repair w
ork to electrical appliances must only be carried out by a suitably
qualified person in strict accordance with current local and national safety
regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages
Problem Cause and remedy
The Empty container
in
dicator lights up. The
programme is
cancelled, the buzzer
sounds.
The condensed water container is full or there is kink
in the
drain hose.
 Empty the contain
er.
 Ch
eck the drain hose.
 Open and close the door whil
e the dryer is
switched on. The indicator light will go out.
The programme is
cancelled.
Th
e buzzer may sound
and the Clean out
airways or Empty
container indicator
flashes.
No obvious cause.
 Switch the dr
yer off and then on again.
 S
tart a programme.
If the programme is cancelled again and a fault
message
appears, there is a fault. Contact Miele
service.
The programme is
cancelled,  lights up
This is not a fault.
In some pr
ogrammes, if the drum has been
underloaded or is empty, the programme will be
cancelled. This can also happen if the items are
already dry.
 Op
en and close the door to resume drying.
 Dr
y individual items using the Warm air timed
drying programme.

Miele TDA 140 C Specifications

General

Cord length	2 m
Control type	Buttons, Rotary
Loading type	Front-load
Drying system	Condensation
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
Cycle time	109 min
Noise level	63 dB
Drying class	-
Drum capacity	7 kg
Current	10 A
AC input voltage	220-230 V
Energy consumption	4.14 kWh
Annual energy consumption	494 kWh

Weight and Dimensions

Depth	580 mm
Width	595 mm
Height	850 mm
Weight	50000 g
Depth with door open	1060 mm