Installation and connection
39
Levelling the dryer
The appliance must stand perfectly
level
on all four feet to ensure safe and
proper operation.
The screw feet can be adjusted to
compensa
te for any unevenness in the
floor.
Do not block the gap between
the
bottom of the tumble dryer and
the floor with plinth facings, deep
pile carpet etc.
This would hinder a sufficient flow of
air t
o the dryer.
Do not obstruct the cool air
i
ntake at the front with a laundry
basket or other objects
This would hinder a sufficient intake
of cool air for the condenser unit.
Room in which the dryer is located
Cool air taken in for the drying process
is e
xpelled from the front of the dryer
and heats up the air in the room.
Ensure that the room has sufficient
ventilation, e.g. by opening a window.
Otherwise drying durations may be
longer.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
co
ndensed water will collect in the area
of the pump. This water can run out if
the tumble dryer is tipped up when it is
being moved. It is a good idea to run
the
Warm air programme for
approximately 1 minute before moving
the tumble dryer. Any remaining
condensed water will then be fed into
the condensed water container or out
through the drain hose.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
