Programmable functions
54
Standby
To save energy, the display goes out
aft
er 10 minutes and the indicator light
for the
Start b
utton starts flashing
slowly.
To come out of Standby mode:
Move
the programme selector or
press
Start. Neither will have any
effect if a pr
ogramme is running.
On
Standby function is activated and the
i
ndicator lights will go out after 10
minutes:
– if a programme is not selected after
the dr
yer has been switched on.
– after a programme has started.
They will, however come on for 10
minu
tes at the end of the programme or
the end of the anti-crease phase. The
buzzer (if selected) will sound for 10
minutes at the end of the programme.
Not in current programme (factory
default setting)
As described under "On".
However
, indicator lights will stay on
when the programme has started and
remain visible during the programme.
Off
Indicator lights will stay on while the
dr
yer is switched on.
Follow steps (,, ...) to
programme and store in memory.
Before you begin, ensure that:
– The tumble dryer is switched off.
– The door is closed.
– The programme selector is pointing
t
o
Finish.
P
ress
Start and k
eep it pressed in
whilst carrying out steps -.
Sw
itch the dryer on.
W
ait until the indicator light for the
Start butt
on lights up constantly . . .
. . . and then release the Start
button.
T
urn the programme selector to
Gentle smoothing.
The Empty container indic
ator light will
flash eight times.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
