Miele WTF 130 WPM User Manual

Settings
107
Suds cooling
When this is activated, additional wa-
ter flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a tem-
perature of 70°C or higher is selected
for the Cottons programme.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where drainage pipes do not comply
with DIN 1986.
Factory default setting: Suds cooling is
switched off.
Low water pressure
If the water pressure is below 100 kPa
the washer-dryer will stop the pro-
gramme and an error message will ap-
pear in the display.
This setting can be activated to ensure
problem free water intake where the
water pressure is constantly low (below
100 kPa).
Factory default setting: Low water pres-
sure is switched off.
Distribution controller
The maximum final spin speed can be
limited to prevent laundry forming a
ring around the drum. This setting is
only effective when washing and dry-
ing in a continuous sequence.
Options
– 1200 rpm (factory setting)
– 1100 rpm
– 1000 rpm
– 900 rpm
Drying levels
You can adjust the drying levels in the
Cottons, Minimum iron and Automatic
programmes.
The drying level is shown in a bar chart:
– Less bars = damper
– More bars = drier

Miele WTF 130 WPM Specifications

General

Door hinge	Right
Control type	Buttons, Rotary
Loading type	Front-load
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
Half-load	-
Drying capacity	4 kg
Washing capacity	7 kg
Delay start (max)	24 h
Spin-drying class	A
Maximum spin speed	1600 RPM
Noise level (wash)	- dB
Water consumption washing per cycle	90 L
Energy consumption washing per cycle	- kWh
Water consumption washing & drying per cycle	- L

Weight and Dimensions

Depth	636 mm
Width	596 mm
Height	850 mm