Installation and connection
91
Aligning the washer-dryer
The washer-dryer must stand perfectly
level on all four feet to ensure safe and
proper operation.
Incorrect installation may increase elec-
tricity and water consumption and may
cause the washer-dryer to move about.
Screwing out and adjusting the feet
The four adjustable screw feet are used
to level the washer-dryer. All four feet
are screwed in when the machine is de-
livered.
Using the spanner supplied turn
counter nut 2 in a clockwise direction.
Then unscrew counter nut 2 together
with foot 1.
Use a spirit level to check the
washer-dryer is standing level.
Hold foot 1 securely with a pipe
wrench. Turn counter nut 2 again us-
ing the spanner supplied until it sits
firmly up against the housing.
All four counter nuts must sit
tight up against the casing. Other-
wise there is a risk of the machine
moving.
Please also check this for the feet
which did not need adjustment.
To Next Page
Loading...
