Miele WTF 130 WPM - Fault messages during operation

What to do if...
75
The following fault messages appear in the display and the
programme stops
Problem Cause and remedy
 Water intake See

The water inlet is blocked or restricted.
 Check whether the stopcock is opened properly.
 Check whether the inlet hose is kinked.
 Check whether the water pressure is too low.
The filter in the water inlet is blocked.
 Clean the filter.
 Drainage See 
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum delivery head is 1 m.
  Service Water-
proof
The water protection system has reacted.
 Close the stopcock.
 Call Service.
  Service Fault F
There is a fault.
 Start the programme again. If the fault message
appears again, contact the Service Department.
To switch off the fault messages: switch the washer-dryer off with the  button.