Minelab Manticore User Manual

CONTENTS
45
Target Tones (Continued)
THE TARGET TONES EDITOR
The Target Tones Editor gives you full control of audio
properties for targets detected within each Tone Region.
The Target Tones Editor shares the same horizontal axis
as the ID Map, with Tone Regions corresponding to the
Target ID. The Tone Regions have adjustable Start and End
points, so you can change the width of each Region.
The volume of each Tone Region can be adjusted separately
to the global Volume setting.
Target ID 0–99
25
25
25
25
25
Tone Region
(e.g. T2)
Pitch 1–50
VolumeStart/End
Points
ADJUST THE VOLUME OF TONE REGIONS
1. Navigate to: Settings > Target Tones
2. Press / to select the Target Tones setting you want
to adjust then press the Right Soft Key (
Edit).
3. Press / to navigate to the Region Volume that you
want to adjust.
25
25
4. Press the Right Soft Key ( Edit). The Region Volume
will highlight in red.
25
25
5. Press / to adjust the Volume ( ).
6. Press (
Back) to return to the top-level of the Editor.
ADJUST THE WIDTH/PITCH OF TONE
REGIONS
1. Navigate to: Settings > Target Tones
2. Press / to select the Target Tones setting you want
to adjust then press the Right Soft Key (
Edit).
3. Press / to navigate to the Start/End Point you want
to adjust.
25
25
4. Press the Right Soft Key ( Edit). The Start/End Point
will highlight in red.
50
5. Press / to move the Start Point ( )
or End Point ( ).
Press / to adjust the Pitch of the
Start/End Point (
).
In 1/2/5-Tone, only one Pitch can be assigned per
Tone Region. Therefore the Start and End Points move
together as the Pitch is adjusted.
16
In the 1/2/5-Region All Tones settings, the Start and
End points can have a different pitch within a Tone
Region. Each point can move independently as the Pitch
is adjusted.
16
6. Press ( Back) to return to the top-level of the Editor.

Minelab Manticore Specifications

General

Brand	Minelab
Model	Manticore
Category	Metal Detector
Language	English