CONTENTS
6
ATTACH THE COIL
1. Confirm that the 2× Coil Washers are in the
Yoke Bracket on the top of the Coil.
2. Slide the Shaft Yoke over the Yoke Bracket, align the
holes, then insert the Bolt through the Yoke and the
Yoke Bracket and tighten by hand. Do not use tools to
tighten, over-tightening may damage the shaft.
EXTEND THE SHAFTS
3. Open the Upper and Lower Camlocks.
4. Extend the Shafts to their approximate detecting
length. Do not extend beyond the red line.
5. Close the Camlocks.
If the Shafts are slipping, they can be adjusted.
See "Tightening the Camlocks" on page 73.
ATTACH THE ARMREST
6. Unlock the Armrest Lock.
7. Slide the Armrest onto the Armrest Rail.
8. Lock the Armrest, then insert your arm into the Armrest
to check the position is correct and adjust as needed —
the armrest should be positioned just below your elbow.
If you are left-handed, you can reverse the Armrest
Strap so that it fastens away from your body for
improved comfort.
CONNECT THE COIL
9. Wrap the Coil Cable around the Shaft enough times to
take up the slack, but so the Coil can still tilt
without restriction.
10. With the arrow on the Coil Connector at the top, align
the Coil Connector with the Interface on the back of the
Control Pod. Plug-in and tighten the Retaining Ring.
Assembly
1
6
9
10
8
7
2
5
3
4
To Next Page
Loading...
Need help?
General
