Minelab Manticore User Manual

CONTENTS
63
Wireless Headphones
ML 105 WIRELESS HEADPHONES
MANTICORE is supplied with Minelab ML 105 low-latency
wireless headphones. ML 105 headphones can also be
used as wired headphones — see "Wired Headphones" on
page 64.
For detailed information on charging, pairing and other
controls, refer to the instructions supplied with the
headphones. The instructions can also be downloaded at
www.minelab.com/support/downloads/product-manuals-
guides.
Minelab ML 105
Wireless Headphones.
PAIR WIRELESS HEADPHONES
1. Long-press (2 seconds) the Wireless Side Button
( ) to initiate Wireless Pairing mode. The Wireless
Audio Indicator ( ) in the Status Bar will flash rapidly.
2. Press-and-hold the Multi Function Button (the centre
button) on the ML 105 headphones until the Status LED
flashes red and blue.
3. Your headphones will connect automatically — the
Wireless Audio Indicator (
) in the Status Bar will
remain On, and the LED on the headphones will flash
blue once every 3 seconds.
If no connection is made within 5 minutes, Wireless
Audio will automatically turn Off.
RE-CONNECT PREVIOUSLY PAIRED
HEADPHONES
1. Press the Wireless Side Button ( ) to turn wireless On.
2. Press the Multi Function Button (the centre button) on
the ML 105 headphones to turn them On.
3. The headphones will re-connect automatically.
THE WIRELESS AUDIO INDICATOR
The Wireless icon appears in the Status Bar when Wireless
is On. It indicates the current Wireless connection status
depending on its display state.
 Rapid flashing: Detector is attempting to pair.
 Solid on: Detector is connected to wireless headphones
accompanied by the Headphones Connectivity icon.
 Slow flashing: The detector is attempting to re-connect
with previously-paired wireless headphones.
FACTORY RESET THE HEADPHONES
Refer to the instructions supplied with the headphones.

Minelab Manticore Specifications

General

Brand	Minelab
Model	Manticore
Category	Metal Detector
Language	English