– 49 –
Operator Settings
Specify the ID, password of the operator.
1. Press the OPERATOR SETTING button on the OPERATOR MENU screen.
page 10
4
5
2
3
2. Setting and viewing the ID
Specify the operator’s ID.
Press ID to input an ID. The input ID is displayed.
3. Setting and viewing the Password
Specify the password of the central control.
Press Password to input a password. The input password is displayed.
4. Setting the operator information
You can specify the operator information.
You can enter text up to 3 lines maximum. When you begin a new line, press the
buttons.
5. Press the SET button.
Press the Cancel button to cancel the change.
Note
Up to 16 one-byte alphanumeric characters can be used for the ID, and up to 8 one-byte
alphanumeric characters for the password.
To Next Page
Loading...
Need help?
General
