To Next Page

To Previous Page

Getting Started 1 - 7

These settings are configurable and the factory default settings are shown in Table 1-3 are subject to

change/update.

Micro Secure Digital (microSD) Card

The microSD card slot provides secondary non-volatile storage. The slot is located on the side of the MC75A (see

Figure 1-5). Refer to the documentation provided with the card for more information, and follow the manufacturer’s

recommendations for use.

To install the microSD card:

1. Remove the memory card cover on the side of the MC75A by loosening the two captive screws.

Table 1-3

Wake-up Default Settings

Condition for Wake-up Power Button Automatic Time-out

AC power is applied to the MC75A. No Yes

The MC75A is inserted into a cradle. No Yes

The MC75A is removed from a cradle. No Yes

The MC75A is connected to a USB cable. Yes Yes

Mobile computer is disconnected from a USB device. No Yes

Mobile computer is connected from a USB Host device. No No

A key is pressed. No Yes

The scan button is pressed. No Yes

The screen is touched. No No

Audio Jack No No

Audio Btn Yes No

A Bluetooth device tries to communicate with the

MC75A.

Yes Yes

On Motion No Yes

The MC75A is connected to a serial accessory. No Yes

Incoming phone call Yes Yes

CAUTION Follow proper ESD precautions to avoid damaging the SD card. Proper ESD precautions include, but

are not limited to, working on an ESD mat and ensuring that the operator is properly grounded.

Motorola MC75A Integrator Guide

Other manuals for Motorola MC75A