54 Managing the Phone Book
Using Pauses in Numbers
When you call automated systems, a recorded
message prompts you for numbers such as PIN
numbers and account numbers. You can store
these numbers in the same memory location as the
automated system’s access number. Separate the
numbers with “pauses”—special characters that tell
your phone to wait a few seconds before sending
additional numbers—and store the string in the
same way you would other numbers.
Tip:
You can
store as many
as 16
characters.
A pause is
equal to one
character.
Enter Pauses in Numbers
1.
Enter the phone number you use to access
the automated system.
2.
Press and hold ß. You will see a pause
character (
Ü) inserted into the number entry.
3.
Enter the next group of numbers. For
example, enter your PIN number. If the
automated system requires a * or #, enter
those symbols, too.
4.
Repeat steps 2 to 3 as many times as
necessary.
5.
To store the entry follow the procedures in
“Add an Entry” on page 50.
Dial Numbers With Pauses
To dial a number with pauses:
1.
Recall the entry. (See “Recalling Entries” on
page 56.)
2.
Press ø to place the call.
The first pause in the number waits until the
call is answered. When the automated
system answers, your phone waits a few
seconds and then automatically sends the
next set of numbers, then the next, until all
numbers are sent.
Mobile.book Page 54 Wednesday, September 9, 1998 3:05 PM
To Next Page
Loading...
Need help?
General
