Nikon Eclipse LV100DA-U User Manual

78
2
Attaching the Condenser
Attach the condenser as described below.
1 Rotate the coarse focus knob until the stage is
raised to the uppermost position.
2 Turn the condenser focus knob until the
condenser holder is lowered to the limit position.
3 Insert the condenser into the condenser holder
with fitting the circular dovetail joints.
When a scale is labeled on the condenser, the
scale must face toward the front.
4 Tighten the clamp screw on the left side of the
condenser holder to fix the condenser.
Use the hexagonal wrench to tighten the clamp screw.
OBJ.
CU
BE
A
.
S
.
EPI
DI
A
EPI
D
I
A
Achr
N.A
0.
9
0
.2
0.
3
0.4
0.5
0.6
0.7
0.8
=
Condenser
focus knob
Condenser
Condenser
clamp screw
To use a high numerical aperture (NA) condenser
To use a high NA condenser such as a slide condenser, remove the standard stage glass on
the stage and then attach the glass slide holder in place. A high NA condenser and the
standard stage glass can collide with each other. Be sure to change the stage glass to the
glass slide holder.
egatS resnednocelbacilppA
egats2x3 citamorhcaedilsx001-2,resnednocDWL,resnednoccitamorhca,resnednocebbA
resnednoclasrevinuDUC-VLdna,resnednocnoitacifingamwol,resnednoc
.resnednocDWLehtroftpecxesresnednocllarofdesusiredlohedilsssalgA*
egatsralugnatceR
egatsralugnatcerelbatatoR
citamorhcaedilsx001-2,resnednocDWL,resnednoccitamorhca,resnednocebbA
dleif-krad,resnednoclasrevinuDUC-VL,resnednocnoitacifingamwol,resnednoc
tanalpacitamorhcadna,resnednoccitamorhcatuo-gniwsnoitaziralop,)yrd(resnednoc
resnednoc
egats4x6 resnednocDWL
Selecting the condenser
Applicable condenser differs depending on the used stage. Refer to the following table to select a
condenser.

Nikon Eclipse LV100DA-U Specifications

General

Brand	Nikon
Model	Eclipse LV100DA-U
Category	Microscope
Language	English