9 Error Messages
172 Nikon N Series/K Series Total Station Instruction Manual
Cogo
NO Result 90.1
The system was unable to calculate an area because points were not entered in the
correct order.
Press any key to return to the Cogo menu. Then enter the points in the correct order.
Same Coordinate 90.2
The point or coordinate that you entered is identical to the previous input point.
Press any key to return to the point input screen. Then use a different point.
XY-coordinate is required 90.3
The input point does not have XY (NE) coordinates.
Press any key to return to the point input screen. Then enter a point that has X and
Y coordinates.
Communications
If an error is detected during uploading of data, the Nikon N Series/K Series
instrument aborts the upload process and displays one of the following messages.
Check Data 90.4
There are errors in the uploaded data. The uploaded data contains errors, such as an
alphabetic character in a coordinate field.
Press any key. Then check the specified line in the data.
DUPLICATE PT 90.5
The uploaded data contains a duplicate PT.
Press any key. Then check the specified point in the data.
B
Tip – If the existing point is a UP, CC, or MP record, and is not referred by ST or BS, then it will
be overwritten by the uploaded record. No error message appears.
PT MAX20 chars
90.6
The uploaded data contains a PT with a name or number that is longer than 20 digits.
Press any key. Then check the specified line in the data.
XYZ OVERRANGE 90.7
The uploaded data contains a coordinate that is longer than 13 digits.
Press any key. Then check the specified line in the data.
To Next Page
Loading...
Need help?
General
