Getting Started 3
Pulse Laser Station NPL-302 Series Instruction Manual 31
Changing Regional Configuration Pre-sets 3.1
To provide easier configuration for common regional settings, you can quickly
configure the Nikon total station to a pre-set combination of default regional
settings. The Regional Configuration screen appears only after the language
configuration is complete, the instrument has rebooted, and the telescope has been
tilted. To change the regional configuration pre-sets:
1. Follow the steps in Selecting a Language, page 30.
After the instrument reboots and the
telescope is tilted, the Regional
Configuration screen appears.
2. Press [^] or [v] to highlight the required
regional settings and then press
[ENT].
3. If you do not want to change the current
settings, press
[ESC] and quit. The
instrument will continue to use the last settings that were configured.
The settings affected by the Regional Configuration screen are:
Table 3.1 Regional Configuration Pre-sets
Category Setting Europe International United States
Angle
VA zero Zenith Zenith Zenith
Resolution 1" 1" 1"
HA Azimuth Azimuth Azimuth
Distance
Scale 1.000000 1.000000 1.000000
T-P corr. On On On
Sea Level Off Off Off
C&R corr. 0.132 0.132 0.132
Coordinates
Order ENZ ENZ NEZ
Label ENZ ENZ NEZ
To Next Page
Loading...
Need help?
General
