Appendix F: Type Codes Type Codes for Input Devices
104
NFS-640 Programming Manual P/N 51333:B 10/03/2003
Type Codes for Input Devices
Overview
This section provides Type Codes for intelligent detectors and monitor modules. For instructions on
programming Type Codes, refer to “How to Modify or Delete a Point (2=point)” on page 21.
Type Codes for Intelligent Detectors
A list of intelligent detector Type Codes, which specify the type of detector installed at an SLC address.
Table 32 Intelligent Detector Type Codes
Type Code
Point Characteristics
Device Function
Point Type
Latching
(Y/N)
Point Function
SMOKE (ION) fire alarm Y lights fire alarm LED and activates CBE Ionization smoke detector
SMOKE(DUCTI) fire alarm Y lights fire alarm LED and activates CBE Duct Ionization smoke detector
SUP.T(DUCTI)** supervisory N lights supervisory LED Ionization smoke detector used as a duct detector to report
supervisory condition rather than alarm. Tracking.
SUP.L(DUCTI) supervisory Y lights supervisory LED Ionization smoke detector used as a duct detector to report
supervisory condition rather than alarm. Latching.
SUP.T(ION)** supervisory N lights supervisory LED Ionization smoke detector used to report supervisory
condition rather than alarm. Tracking.
SUP.L(ION) supervisory Y lights supervisory LED Ionization smoke detector used to report supervisory
condition rather than alarm. Latching.
SMOKE(PHOTO) fire alarm Y lights fire alarm LED and activates CBE Photoelectric smoke detector
SMOKE(DUCTP) fire alarm Y lights fire alarm LED and activates CBE Duct Photoelectric smoke detector
SUP.T(DUCTP)** supervisory N lights supervisory LED Photoelectric smoke detector used as a duct detector to
report supervisory condition rather than alarm. Tracking.
SUP.L(DUCTP) supervisory Y lights supervisory LED Photoelectric smoke detector used as a duct detector to
report supervisory condition rather than alarm. Latching.
SUP.T(PHOTO)** supervisory N lights supervisory LED Photoelectric smoke detector used to report supervisory
condition rather than alarm. Tracking.
SUP.L(PHOTO) supervisory Y lights supervisory LED Photoelectric smoke detector used to report supervisory
condition rather than alarm. Latching.
RF_SMOKE fire alarm Y lights fire alarm LED and activates CBE Wireless Photoelectric smoke detector
SMOKE(HARSH)* fire alarm Y lights fire alarm LED and activates CBE HARSH smoke detector
SMOKE(LASER) fire alarm Y lights fire alarm LED and activates CBE Laser smoke detector
AIR REF fire alarm Y lights fire alarm LED and activates CBE Assign to one or more FSL-751 detectors used to monitor the
quality of air entering the protected area. The air quality
measurement allows the VIEW® system to compensate for
vehicle fumes, fog, or other particles brought into the protected
area through the ventilation system. Poor air quality will lower
the sensitivity of all FSL-751 detectors on the SLC. The
detector sensitivity, however, remains within approved limits
(always less than 1% obscuration per foot).
Note: A reference detector still functions as a smoke detector, but you should set the detector sensitivity level to the least sensitive level—AL:9 and
PA:9 Change Alarm and Pre-Alarm sensitivity. Refer to “Detector Sensitivity Settings” on page 90 for a complete list of detector sensitivity settings.
HEAT fire alarm Y lights fire alarm LED and activates CBE 190
o
F intelligent thermal sensor
HEAT+ fire alarm Y lights fire alarm LED and activates CBE 190
o
F intelligent thermal sensor with low temperature warning.
HEAT(ANALOG) fire alarm Y lights fire alarm LED and activates CBE 135
o
F intelligent thermal sensor
HEAT (ROR) fire alarm Y lights fire alarm LED and activates CBE
15
o
F per minute rate-of-rise detector
SMOKE ACCLIM fire alarm Y lights fire alarm LED and activates CBE Combination Photoelectric/heat detector without freeze
warning (Acclimate Plus™)
SMOKE(ACCLI+) fire alarm Y lights fire alarm LED and activates CBE Combination Photoelectric/heat detector with freeze
warning (Acclimate Plus™)
SMOKE(MULTI)* fire alarm Y lights fire alarm LED and activates CBE Multisensor smoke detector
* CLIP Mode only
**Not suitable for Canadian applications.
www.PDF-Zoo.com