How to Use the Basic Program 2. Program Change
NFS-640 Programming Manual P/N 51333:B 10/03/2003 21
How to Modify or Delete a Point (2=POINT)
After programming all SLC-connected devices into the system, you can modify
or delete points. From the “Basic Program” screen, press the 2 key to display the
Point Programming screen:
To modify a point for a detector, module, or NAC/Panel Circuit: press the 1 key to
display the “Modify Point” screen.
To delete a point for a detector, module, or NAC/Panel Circuit: press the 2 key to display the “Delete
Point” screen.
The Modify Point and Delete Point screens let you edit or delete points for a detector, a monitor or
control module, NAC or Panel Circuit. To select a point, follow these steps:
The next four sections describe how to program the points selected.
To select Do the following Refer to
an addressable
detector
Press
Type the SLC number (1 or 2) and
detector (D) and address (001-159)
Press
“How to Modify an Addressable
Detector Point” on page 22
an addressable monitor
module
Press
Type the SLC number (1 or 2) and
module (M) and address (001-159)
Press
“How to Modify an Addressable
Monitor Module Point” on page
23
an addressable control
module
Press
Type the SLC number (1 or 2) and
module (M) and address (001-159)
Press
“How to Modify an Addressable
Control Module Point” on page
24
a NAC or Panel Circuit
Press
Type the NAC address (01-04) or Panel
Circuit address: (1-1) through (8-8)
Press
“How to Modify NAC and
Panel Circuit Points” on page 25
Program Change
Password
POINT PROG. 1=MODIFY POINT
2=DELETE POINT
Press for module point
SLC number
Three-digit address (001-159)
E - press the
ENTER key
Press for detector point.
SLC number
Three-digit address (001-159)
Press for NAC
or Panel Circuit
Modify Point Screen
Delete Point Screen
E - press the
ENTER key
POINT PROG. ENTER:DETECTOR=*,LDAAA,E
MODULE=#,LMAAA,E OUTPUT CKT=&,A-A,E
E - press the
ENTER key
Two-digit address: NAC
(01-04) or panel Circuit
(1-1) through (8-8)
DELETE POINT. ENTER:DETECTOR=*,LDAAA,E
MODULE=#,LMAAA,E OUTPUT CKT=&,A-A,E
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
