Type Codes for Output Devices Appendix F: Type Codes
NFS-640 Programming Manual P/N 51333:B 10/03/2003 107
NAC and Panel Circuit Type Codes
A comprehensive list of Type Codes for panel NACs and Panel Circuits. The Type Codes that display,
however, depend on the type of circuit: NAC or Panel Circuit relay. For instructions on programming
Type Codes, refer to “How to Modify or Delete a Point (2=point)” on page 21.
Note: Do not assign Releasing Type Codes to Panel Circuits with the exception of the audible Type Codes REL END
BELL and REL AUDIBLE.
Table 35 NAC and Panel Circuit Type Codes
Type Code
Silenceable
(Y/N)
Configuration Device Function
CONTROL Y Panel Circuit relay or NAC Supervised NAC
RELAY Y Panel Circuit relay Relay output
BELL CIRCUIT Y Panel Circuit relay or NAC Supervised NAC for notification appliance
STROBE CKT Y Panel Circuit relay or NAC Supervised NAC for notification appliance
HORN CIRCUIT Y Panel Circuit relay or NAC Supervised NAC for notification appliance
AUDIBLE CKT Y Panel Circuit relay or NAC Supervised NAC for notification appliance
SPEAKER N Panel Circuit relay only Supervised NAC for speaker circuits
REL END BELL N Panel Circuit or NAC Supervised NAC
blank label Y Panel Circuit relay or NAC Supervised NAC for undefined device
REL CKT ULC N NAC Releasing Circuit, power-limited, supervised for opens, shorts and ground
faults (always non-silenceable)
RELEASE CKT N NAC Releasing circuit, nonpower-limited, supervised for opens and ground faults
REL AUDIBLE Y Panel Circuit or NAC NAC, activated upon release
TELEPHONE N Panel Circuit relay only Standard Telephone circuit
REL CODE
BELL
Y NAC only Supervised NAC (NFS-640 NAC only)
INSTANT RELE N NAC NAC, short = normal; supervised for open circuits and ground faults. Always
non-silenceable and switch-inhibited.
ALARMS PEND N Panel Circuit or NAC Output that will activate upon receipt of an alarm condition, and remain in the
alarm state until all alarms have been acknowledged. It is programmed as “switch
inhibit”.
CONTROL NAC Y Panel Circuit relay or NAC Supervised NAC
GEN ALARM N NAC
Control Module, an XPC-8 circuit, or an
XP5-C (in NAC mode) configured as a
Municipal Box Transmitter for NFPA 72-1999 Auxiliary Fire Alarm Systems
applications (MBT-1 required). This Type ID can also be used for general alarm
activation. It is programmed as “switch inhibit”.
GEN SUPERVIS N NAC
Control Module, an XPR-8 relay, or an
XP5-C (in relay mode) activated under
any Supervisory condition (includes sprinkler type). It is programmed as “switch
inhibit”.
GEN TROUBLE N NAC
Control Module, an XPR-8 relay, or an
XP5-C (in relay mode) activated under
any System Trouble condition. It is programmed as “switch inhibit”.
GENERAL
PEND
N NAC
Control Module, an XPC-8 circuit, or an
XP5-C (in NAC mode) that will
activate upon receipt of an alarm and/or trouble condition, and remain in the
ON state until all events have been ACKNOWLEDGED.
TROUBLE PEND N NAC
Control Module, an XPC-8 circuit, or an
XP5-C (in NAC mode) that will
activate upon receipt of a trouble condition, and remain in the ON state until all
troubles have been ACKNOWLEDGED. It is programmed as “switch inhibit”.
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
