14 NFS-640 Programming Manual P/N 51333:B 10/03/2003
2. Program Change
What is Program Change?
Program Change is the programming level that lets you change the essential control panel functions,
such as point programming, changing passwords, changing system functions. Included are four
selections: Basic Program, Network, FlashScan Poll, and Utility Program.
The structure of the Program Change option is shown below:
Figure 2 Program Change Selections
In This Section
This section contains instructions and sample screens for using the Program Change selections:
• Basic Program The Basic Program lets you program essential functions, such as clearing the
program, Autoprogramming the system, programming points, and setting system functions.
Refer to “How to Use the Basic Program” on page 15.
• Network Program The Network Program allows programming of network channel
thresholds, network node number, and wiring style.“How to Use the Network Program” on
page 42.
• Utility Program The Utility Program screen provides selections for Dynamic Polling of the
SLC(s), selecting a Trouble Reminder per NFPA, and enabling or disabling local control of the
ACKNOWLEDGE/SCROLL DISPLAY, SIGNAL SILENCE, and SYSTEM RESET keys. Refer to “How to
Use the Utility Program” on page 43.
• FlashScan Poll The FlashScan Poll screen provides the option for selecting between CLIP
(Classic Loop Interface Poll) and FlashScan Poll. Refer to “How to Use FlashScan Poll” on
page 44.
Choose one of the Program Change selections: 1, 2, 3 or 4
1 Basic Program options
3 Utility Program options
4 FlashScan Poll options
2 Network Program options
1=BASIC PROGRAM 2=NETWORK
3-UTILITY 4=FLASHSCAN POLL
0=CLR 1=AUTO 2=POINT 3=PASSWD 4=MESSAGE
5=ZONES 6=SPL FUNCT 7=SYSTEM 8=CHECK PRG
THRESHOLD CH.A:H, THRESHOLD CH.B:H
NODE: .000, STYLE7:Y, <ENTER>
DYN.POLL=N TBL.REMIND=2 ALA.SCROLL=N
LOCAL CONTROL=Y
FLASHSCAN L1DET L1MOD L2DET L2MOD
NYNY
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
