2. Program Change How to Use the Network Program
42
NFS-640 Programming Manual P/N 51333:B 10/03/2003
How to Use the Network Program
From the “Program Change Selection” screen, press the 2 key to display the
“Network” screen, which displays as follows:
THRESHOLD CH.A: - Enter H or L, for high or low threshold setting for channel A on the NCM
module.
THRESHOLD CH.B: - Enter H or L, for high or low threshold setting for channel B on the NCM
module.
NODE: - Enter the panel’s network node number. The valid network node number range is 1-103. The
number will be entered after the decimal point; the spaces before the decimal point are for future use.
STYLE7: - Enter N for network style determination (either Style 4 or Style 7) through
autoprogramming. Enter Y to force a Style 7 designation for network wiring.
Note: If network Style 7 wiring is determined by autoprogramming, a change in the wiring (for example, a break in the
network wiring) would cause the system to reassess the network wiring style as 4. If network Style 7 wiring is forced, a
break in the wiring will create a trouble message.
How to Select the Network Program Options
To select network options, follow these steps:
1. Using the arrow keys, move the blinking cursor to a selection.
2. Press the
NEXT or PREVIOUS key to select H or L (Threshold Ch. A, Threshold Ch. B). a three-digit
number (Node), or Y or N (Style 7).
When finished making selections, press the
ESC key three times to return the control panel to normal
operation.
When programming is complete, the panel must be reset to register the programming.
Program Change
Password
THRESHOLD CH.A:H, THRESHOLD CH.B:H,
NODE: .000, STYLE7:N, <ENTER>
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
